Rooftop solar installation
Watertight supports for fixing PV structures to roofs waterproofed with PVC, TPO or bituminous membranes, without breaching the waterproofing.
Where it is used. PV installations on flat membrane roofs on industrial buildings, shopping centres and other buildings, new or on existing roofs.

How to install
- Set out the supports according to the PV structure and the wind load calculation.
- Fix the base of each support to the roof deck (steel, concrete or timber) through the insulation.
- Weld a compatible membrane patch (PVC, TPO or bituminous) over the base to restore watertightness.
- Mount the rails on the M10 studs and the panels on the rails.
- Complete the roof with Rego lifelines and VILPE Sense moisture detection.
Recommended fasteners
Data sheets and DoPs →PVC membrane
FYT Waterfix PVC M10FYT Waterfix M10 consists of a pre-drilled round fixing base and an M10 carbon steel stud tested to 700 hours of salt spray.
FYT Waterfix PVC RS20FYT Waterfix RS 20 consists of a pre-drilled rectangular fixing base with rounded corners and a standard rectangular carbon steel tube.TPO membrane
Bituminous membrane
Safety and monitoring
Guidance only. The type, length and number of fasteners depend on the project, the substrate and the wind uplift calculation; please consult us for each project.











